Re: ChannelPlus 1538

On Apr 30, 5:31=A0pm, BH <bha...@[EMAIL PROTECTED]
> wrote:
 > On Apr 30, 8:24=A0pm, rlew...@[EMAIL PROTECTED]
 (Cass Lewart) wrote:
 >
 > > BH (bha...@[EMAIL PROTECTED]
) wrote:
 >
 > > : Can anyone tell me if this amp will work with HD? Thanks!
 > > : Bruce
 >
 > > Try it or check the specs that it covers UHF, I am using a RS in
 > > line RF amplifier for around $30 and it works great.
 > > Cass
 >
 > Hello again:
 >
 > It is obvious that I asked my question poorly. The installation in
 > question was done by me 4 years ago and consists of ~ 10 outlets.
It
 > has performed quite well with excellent picture quality. The owner
got
 > a new Panasonic 42" plasma last week and pix breaks up on the HD
 > channels often. Initially it was a HDMI set up with a Audio Video
 > receiver in the system. Initially we pulled out the receiver and
got
 > no improvement. It is now just the cable line direct to the TV and
 > seems to be OK. The cable co. says the amp will not pass the HD
signal
 > (????) and that is why I asked about this model amp. Their
statement
 > was that it was fine for analog but not for digital.
 >
 > Thanks,
 >
 > Bruce

Actually analog is more difficult than digital. Once you get more than
15 dB signal-to-noise you're pretty much home free with digital. 15 dB
in analog is the PITS. Perhaps Elmo would find it OK since he can
still see the story. That amp is good from channel 2 (50MHz) to
channel 83 (950MHz) and fine for analog and digital. Cable folks are
mistaken.

GG